miniature ball bearings Bearing selection issues to consider

In the choice of the general bearing support to those problems? You can try the following four steps to consider:

How to define the axis position, including radial and axial position is the first thing to consider. General axis adopts double support structure, the radial position of the shaft joint is defined by the two support, centripetal or angular contact bearing supports radial location of each Ying Youqi effect. miniature ball bearings‍ Axial displacement axial displacement axial position may be composed of two supporting the limit in one direction can be limited in two directions by a bearing, in general, the axial positioning in different ways can get different running accuracy. Therefore, the design of supporting structure should be based on the axis of the operation accuracy and working conditions, practical scheme of axial positioning.

At the same time bear radial load and axial load case, supporting often use mounting angular contact bearings and tapered roller bearings are. Angular contact bearings installed in pairs arranged in one of three ways. Two bearing outer ring width end relative installation called back-to-back mounting method. The two support force on bearing span beyond. This arrangement for supporting span large, good steel shaft cantilever, axial thermal elongation, the outer ring is disengaged from the inner trend, so the shaft without jamming, so widely used. Double Row Ball Slewing Bearing‍ But if the pre installed in the shaft when heated, pre tension will be reduced. Two bearing outer ring narrow end relative installation called face to face mounting. The force point two support falls on the supporting span. This arrangement has the advantages of simple structure, installation, debugging convenient and therefore are more widely used, mainly for short axis and the temperature rise is not high, but it should be noted that we must have a spare clearance. The axial clearance also shoulds not be too big, will reduce the running accuracy of the shaft. When the axial load is larger, the need for multiple bearings and bearing, the bearing outer ring worm gear speed reducer‍ width is often used, narrow face relative installation series. Effect of the bearing force are located on the same side of the bearing are arranged in the same direction is also called series. The arrangement of this to the attention of the structure and manufacture to ensure each bearing can be as much as possible uniform load.