After the bearings were cleaned thoroughly washed with clean kerosene, grease lubrication, the first containing 3% to 5% of the grease into the bearing organic solvents for degreasing and cleaning, and then quantitative grease gun oil filled bearing (accounting bearing space volume of 10% to 15%); Full complement cylindrical roller bearings heating bearings make heating 20 ~ 30 ℃, oil presses the bearing into the shaft; pressure in the tight sets with suitable pressure shaft and bearing against the end face axially the spring balance tape volumes on the bearing outer ring, pre-load starting torque measuring method stipulated check whether a substantial change (even if the bearing is correct, but due to meet or maintain the deformed frame, pre-load there; positioning changes possible).
(3) the bearing shaft assembly into the seat hole
Heated seat hole so that heating 20 ~ 30 ℃, with continuous gentle pressure on the bearing shaft assembly into the housing bore;? Before adjusting cover, tighten the amount of the front cover of 0.02 ~ 0.05μm, to the outer end face of the bearing housing benchmark indicator of the conflict in the journal header surface, the axis of rotation measured beat, require error 10μm or less; will dial gauge positioned on the shaft hole in precision spindle bearings the surface of the back seat of the header conflict, the rotation axis to measure the bearing housing bore concentricity before.
(4) the free end of the bearing may be selectively placed in the position deviation offset mounted to the bearing support position, to offset possible concentricity and roundness deviation of the deviation between each other.
没有评论:
发表评论